Cut through the side section at the marked separation point in the lower side member using the oscillating body saw. 用摆动式车身锯在下侧梁标记的分离点处切断侧断面。
Cutting through the outer hinge pillarcut through the outer hinge pillar at the marked separation point in the side member using the oscillating body saw. 切断外铰链柱使用振荡车身锯在侧梁内标记的分离点处切断外铰链柱。
Micro-shear stress sensor plays an important role in detecting separation point of the boundary layer due to small-scale structures and the desired spatial and temporal resolution. 微型剪应力传感器以尺寸小、时空分辨率高的特点在边界层分离点测量中表现出了突出的优势。
Determination of economic haul separation point in analysis of freight and miscellaneous charges 运杂费分析中经济运距分界点的确定
The effect is unsatisfactory in the event of slotted suction far away from the upstream or downstream of separation point. 而在分离区上游或者分离区下游的较远处开缝抽吸,则效果不理想。
The position of the separation point and the shape of the separation wake are simultaneously determined in the iterative procedure. 分离尾流边界的形状与分离点位置在迭代求解过程中确定。
The separation flow around a sphere is calculated and the position of the separation point is determined. 同时还对圆球的分离流动作了计算,得到了流动的分离点。
Having the aid of position coordinate of reference separation point, the point can be moved to outlet of vane by changing coefficient of vane shape. 借助于分离参考点的位置坐标,通过改变叶片形状系数,能有效地使分离参考点移向叶片出口端。
Study Of Fiber Separation Point In Birch Pulping 桦木制浆纤维分离点的研究
The correlation between the fluctuating pressure at separation point of two circular cylinders; 两个圆柱之间分离点压力的相关分析和相位关系;
This design proposal of micro pressure sensor array can effectively meeting the measuring requirement of boundary-layer separation point, and expand engineering applied scope of MEMS devices. 设计的微型压力传感器阵列可有效满足边界层分离点的检测要求,进一步拓展了MEMS器件的工程应用范围。
The streamline behavior near separation point of steady and unsteady viscous flow is studied, and the separation criteria are discussed. 本文研究了分离点附近流线的性状,并在此基础上对二维不可压缩定常、非定常流动的分离判据作了讨论。
It is proved that closer to outlet from reference separation point, better test property has the pump. 试验验证了分离参考点越靠近叶片的出口端,泵的测试性能越好。
Boundary Layer Separation Point Real Time Detection System Based on DSP 基于DSP的边界层分离点实时检测系统
The effect of the ratio a/ b on the separation point of boundary layer is discussed. 讨论了a/b对边界层分离点的影响。
The equations for determining separation point and stress intensity factor were put forward in this paper. The Mach reflection is shaped when detonation waves propagate on a wedge. 解决了一外形轮廓曲线为f(χ)的刚性楔块插入半无限长裂纹问题,建立了求解分离坐标和应力强度因子的方程式.爆轰波在通过楔块时会发生Mach反射。
The detection of the location of the separation point of the boundary layer is very important, which is used for active flow control and smart skin adaptive control system. 边界层分离点检测是实现分离流主动控制的前提和基础,也是气动控制灵巧蒙皮系统研究的重点和难点。
This paper analyzes and studies on the jet separation point, which are based on the former research findings and in the end brings forward a equation for calculation the distance of the jet separation. 对射流分离距离进行了详细的分析与深入的研究,总结了前人的研究成果,结合低温送风系统的特点,提出了低温送风系统的射流分离距离新的计算公式。
The rendezvous error between launch vehicle and target forecast is caused by separation point error of intercept. 运载器弹道与预测命中点之间的交会误差是拦截器分离点误差引起的。
The streamline behaviour near a separation point of two dimensional steady and unsteady viscous flow is studied, and a general criterion for flow separation is presented in this paper. 本文研究了定常、非定常二维粘性不可压缩流动在分离点附近的流线性状,给出了判定分离的通用判据。并指出:M。
If the reference separation point approaches the outlet, the test results are satisfactory, which state that the practical position of boundary layer separation point will be close to the outlet. 若分离参考点接近于出口端,则可获得满意的测试结果,这说明边界层实际分离点的位置已经很接近于叶片的出口端。
To investigate the cross flow induced vibration of heat exchanger tube bundles, a separation point determination model and a fluid-structure interaction model based on surface vorticity method are proposed. 为了研究热交换器中管束的流体诱导振动问题,提出了一种基于表面涡方法的圆柱绕流计算模型,包括分离点计算模型和流固耦合模型。
And further, the problem of determining the separation point is dealt with. 此外还处理了确定分离点位置的问题。
The design and integration methods of micro thermal sensor array, sensor array driver circuit, dynamic data acquisition circuit, and criterion algorithm of the boundary layer separation point were presented in the thesis. 本文以边界层分离点检测技术为研究对象,对微型传感器阵列的设计与集成、阵列驱动电路、数据采集电路以及分离点判定算法进行研究。
Through analyzing the methods and combination of the low speed wind tunnel test data, the position of the separation point can be detected accurately. 通过对试验结果进行数据处理,验证了该判定方法对分离点位置判定的正确性和有效性。
Moving Control of Separation Point on Two-phase Flow Boundary Layer in Centrifugal Pump Vane 离心泵叶片两相流边界层分离点移动控制
The introduction of micro pressure sensor array expands ways detecting boundary layer separation point. 微型压力传感器阵列的引入,拓宽了边界层分离点检测的解决途径。
The correlation between fluctuating pressure at separation point and those around the whole circumference, and the correlation between fluctuating aerodynamic forces and fluctuating pressure around the whole circumference; 分离点脉动压力和圆柱周向压力分布的相关情况,以及脉动气动力和周向压力分布的相关情况;
Our results show that all these factors have no or very little effects on the determination of phase separation point, but have some on the retention characteristics after the second transition point during the course of phase separation. 结果表明,这些因素对相分离点的测定影响很小或没有影响,但影响相分离的第二拐折点后的保留特性。
Based the numerical simulated results of the jet in the cross flow this paper summarizes the rules of the jet angle influence on the position of the vortex center, separation point and dilution. 本文基于对横流环境中窄缝射流的数值模拟结果,分析、总结了横流环境中不同射流比下各种喷角对涡心点、分离点位置以及稀释度的影响规律。